Neptune Amplifier – 50w Amplifier
This amplifier works very well, easily producing 50 watts with a drive around 2 watts. It requires no special interfacing only a cable connected between the amp and radio.
Details:
The HF +50MHz amplifier is custom designed, called NEPTUNE, with LPF (low pass filters), 4x RD16HHF1 transistor based, intended for field or mobile operations or as driver for higher power amplifiers. The amplifier produced from high quality ORIGINAL parts, such as Mitsubishi transistors and AMIDON cores. PA PCB mounted on metal heat-sink for good heat dissipation. PA has 2.5 dB flatness of frequency response and PA can operate 24x7x365 in any digital modes without extra cooling.
Nominal power supply – 13.5v
Nominal current is – 7A
Maximum current is – 10A
Idle current is – 0.8A
Input frequency 1.8, 3.5, 7, 10, 14, 18, 24, 28, 50 MHz
Input and output impedance is 50 Ohm
Input SWR – better than 1.5 for all bands
Nominal input power is 34dBm (2.5W)
Maximum input power is 37dBm (5W)
Nominal output power 47dBm (50W CW)
Maximum output power is 48.5dBm (65W CW)
Measured IMD3 performance is -32dB for nominal power
External PTT signal – GND active
Band switching – manual, by pressing a button
Case size 187x120x80 mm
– Cable included for connect Amplifier to Radio
$400.00 shipped* in Canada
[Tax, Duty & exchange PAID – fast delivery]
* note (if wanted insurance is extra)
The post Neptune 50w Amplifier for QRP rigs – IC-705 – KX3 – KX2 etc first appeared on Hamshack.